Rs-232 Connection - Moxa Technologies EtherDevice Hardware Installation Manual

1. The pin numbers for male DB9 and DB25 connectors,
NOTE
2. The pin numbers for both 8-pin and 10-pin RJ45

RS-232 Connection

Moxa EtherDevice Server has one RS-232 (10-pin RJ45) console
port, located on the top panel. Use either an RJ45-to-DB9 or
RJ45-to-DB25 cable (see the cable wiring diagrams below) to
connect Moxa EtherDevice Server's console port to your PC's
COM port. You may then use a console terminal program, such as
Moxa PComm Terminal Emulator, to access Moxa EtherDevice
Server's console configuration utility.
RJ45 (10-pin) Console Port Pinouts
and hole numbers for female DB9 and DB25
connectors are labeled on the connector. However, the
numbers are typically quite small, so you may need to
use a magnifying glass to see the numbers clearly.
connectors (and ports) are typically not labeled on the
connector (or port). Refer to the Pinout and Cable
Wiring diagrams below to see how RJ45 pins are
numbered.
MOXA EtherDevice Server Hardware Installation Guide
Hardware Overview
3-9