Din-Rail Mounting - Moxa Technologies EtherDevice Hardware Installation Manual

DIN-Rail Mounting

For many industrial applications, you will find it convenient to attach
Moxa EtherDevice Server to a DIN-Rail, as described below. The
green plastic DIN-Rail attachment plate should already be fixed to the
back panel of EDS when you take it out of the box. If you need to
reattach the DIN-Rail attachment plate to EDS, be sure the stiff metal
spring is situated towards the top, as shown in the figures below.
STEP 1:Insert the top of the
DIN-Rail into the slot just
below the stiff metal
spring. Apply a few
pounds of downward
force on the top rear of
the server, and then
rotate the server as
shown below.
To remove Moxa EtherDevice Server from the DIN-Rail, simply
reverse Steps 1 and 2 above. Grasp EDS with both hands, apply a
slight amount of downwards force at the top rear of the server, and
then rotate the bottom of the server towards its front panel. When the
bottom of the DIN-Rail loses contact with the attachment plate, simply
lift the server up and away from the DIN-Rail.
Installing MOXA EtherDevice Server
MOXA EtherDevice Server Hardware Installation Guide
STEP 2:The DIN-Rail
attachment unit will
snap into place as
shown below.
2-3