10/100Basetx Ethernet Port Connection - Moxa Technologies EtherDevice Hardware Installation Manual

Hardware Overview

10/100BaseTx Ethernet Port Connection

The 10/100BaseTX ports located on Moxa EtherDevice Server's
front panel are used to connect to Ethernet-enabled devices. Most
users will choose to configure these ports for Auto MDI/MDI-X
mode, in which case the port's pinouts are automatically adjusted
depending on the type of Ethernet cable used (straight-through or
cross-over), and the type of device (NIC-type or HUB/Switch-type)
connected to the port.
In what follows, we give pinouts for both MDI (NIC-type) ports and
MDI-X (HUB/Switch-type) ports. We also give cable wiring
diagrams for straight-through and cross-over Ethernet cables.
RJ45 (8-pin, MDI) Port Pinouts
MOXA EtherDevice Server Hardware Installation Guide 3-11