Korg Pa50 User Manual page 200

198 Effects
Mod./P.Shift
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
h
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
a: Pre LPF
This parameter enables you to set the damping amount of
the high range sound input to the ring modulator. If the
input sound contains lots of harmonics, the effect may
sound dirty. In this case, cut a certain amount of high
range.
b: OSC Mode
This parameter determines whether or not the oscillator
frequency follows the note number.
c: Fixed Frequency [Hz]
This parameter sets the oscillator frequency when "OSC
Mode" is set to Fixed.
d: Note Offset, d: Note Fine
These parameters for the oscillator are used when "OSC
Mode" is set to Note (Key Follow). The "Note Offset" sets
the pitch difference from the original note in semitone
steps. The "Note Fine" parameter fine-adjusts the pitch in
cent steps. Matching the oscillator frequency with the
note number produces a ring modulation effect in the
correct key.
037: Detune
Dry, 1:99...99:1, Wet
Using this effect, you can obtain a detune effect that offsets
the pitch of the effect sound slightly from the pitch of the
Off...Tempo
input signal. Compared to the chorus effect, a more natural
–100...+100
sound thickness will be created.
a
b
d
e
d: Input Level Dmod [%], d: Src
This parameter sets the dynamic modulation of the input
level.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Input Level
+
Detune
Input Level
Right
Pitch Shift [cent]
Sets the pitch difference from the input signal
Src
Selects the modulation source of the pitch shift
Amt
Sets the modulation amount of the pitch shift
Delay Time [msec]
Sets the delay time
Feedback
Sets the feedback amount
c
High Damp [%]
Sets the damping amount in the high range
Input Level Dmod [%]
Sets the modulation amount of the input level
Src
Selects the modulation source for the input level
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
Input Level Input Level
x1.0
Amt= +50
Amt= +100
x0.5
D -mod
Higher
Zero
Max
Wet / Dry
High Damp
Delay
Feedback
Wet / Dry
–100...+100cent
Off...Tempo
–100...+100cent
0...1000msec
–100...+100
0...100%
–100...+100
,
Off...Tempo
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Input Level D-mod
x1.0
Amt= –50
Amt= –100
x0.5
D -mod
Higher
Zero Max