Web Browser Operations Startup; Static Vs. Dynamic Setup; Figure 3.7: Ipump 6400 Web Browser Control Setup Process; Table 3.2: Ipump 6400 Web Browser Control Setup Procedure - Wegener iPump 6400 User Manual

Operation
For HTML control and status checking from a web browser, first navigate from the home
Web Browser
screen to the IP Setup screen. iPump 6400 operations performed via a web browser are
Operations
described under 3.9 iPump 6400 Operations by Function on page 43.
Startup
Once the web browser access is established, you may change your IP address from the
browser. See Network Setup on page 42.

Static vs. dynamic setup

The iPump 6400 allows you to configure your IP setup as either static or dynamic. The static
setup allows you to set a fixed IP address, whereas a dynamic setup or DHCP (Dynamic
Host Configuration Protocol) selects a temporary IP address from your network. Figure 3.7
and Table 3.2 detail the iPump 6400 Browser Control Setup.
It may be necessary to set the IP address, subnet mask, and gateway to specific values.
Consult your local network administrator to verify the IP address information.
Note:
Begin from the HOME screen.
Step
1.
2.
3.
4.
5.
6.
24

Figure 3.7: iPump 6400 web browser control setup process

Table 3.2: iPump 6400 web browser control setup procedure

Write down the iPump 6400 's IP address displayed on the screen. Then use the steps
listed in Web Browser Access on page 25 to gain control from your browser.
Press
#
UNIT SETUP
ENTER RECORD AND PLAY
#
DECODER SETUP
#
AUDIO SETUP
#
LAN IP SETTINGS
ENTER LAN IP ADDRESSING SELECT: xxxxx
Press Enter to select either STATIC or DHCP for setup .
For more information, see Selectable Fields on page 21.
800009-01 Rev. J
Displayed Screen Type
Menu
Menu
Menu
Menu
Menu
Selectable
www.wegener.com