Pre-Configured Transport In Settings; Navigation To Transport In Setup Screen; Transport In Current Channel Setup; Figure 3.10: Lcd Menu Navigation To Transport In Setup Screen - Wegener iPump 6400 User Manual

for LNB LO Frequency , LNB DC Power , Date and Time , and Unit Label should be made at
this time.
A few of the Transport In Settings ( LNB LO Value , SNR Alarm Threshold , and SNR Margin
Pre-configured
Transport In Warning
operator. Table 3.3 lists these settings as they are originally configured from the factory.
Settings
LNB LO Value
SNR Alarm
Threshold
SNR Margin
Warning
Use the front panel navigation buttons to go to the Transport In Setup screen as shown in
Navigation to
Transport In
Figure 3.10
Setup Screen
Begin from the HOME screen.
1.
2.
3.
4.
5.
6.
Configure the Transport In Current Channel from the Transport In Setup screen.
Transport In
Current Figure 3.11
Channel
Setup
www.wegener.com
) are preconfigured and should only be changed if advised by your satellite

Table 3.3: iPump 6400 pre-configured Transport In Settings

Parameter
Default appropriate for Ku-band reception. 5150 MHz
would be an appropriate setting for C-band operation.
Signal-to-noise ratios below this value results in an alarm
condition.
Warning condition triggered when signal-to-noise ratio is
within 3.0 dB of the SNR Alarm Threshold (under 8.0 dB as
preset).
and Table 3.4 . From the Transport In Setup screen, you can set:
Transport In Current Channel
!"
LNB LO Frequency
!"
LNB DC Power
!"

Figure 3.10: LCD menu navigation to Transport In Setup screen

Table 3.4: Menu navigation to Transport In Setup screen

Step Press
#
ENTER
#
#
#
#
and Table 3.5 detail the procedure for adjusting the Current Channel settings.
Application / Description
Displayed
UNIT SETUP
RECORD AND PLAY
DECODER SETUP
AUDIO SETUP
IP SETUP
TRANSPORT IN SETUP
800009-01 Rev. J
iPump 6400 User's Manual
Preset Value
10750 MHz
5.0 dB
3.0 dB
Screen Type
Menu
Menu
Menu
Menu
Menu
Menu
27