Alarm Connector Details; Table 2.1: Ipump 6400 Connector Details - Wegener iPump 6400 User Manual

Installation
Designation Connector Type
female Type F
RF IN
female BNC
ASI IN
1/8-inch stereo jack
AUDIO*
1/8-inch stereo jack
AUX AUDIO
Mini-DIN4 or BNC
VIDEO*
female RJ-45
LAN
male DB-9
CONTACT
CLOSURE/
ALARM
Male IEC
POWER
receptacle
* See connector details under
with a digital output decoder.
The DB-9 female alarm connector on the rear panel provides contact closures and openings
Alarm
during alarm conditions as well as a user relay available for control by Compel command
Connector
(USER CC). Normal conditions represent the contact in normally functioning, powered
Details
operation. Other conditions or commands will reverse the status of the contact from its
normal position.
Pin functions of the DB-9 alarm connector are listed in Table 2.2 . Pin 1 is the common
connection used by both pins 2 and 6. In alarm mode, Pins 1 and 2 are connected together.
When not in alarm mode, Pins 1 and 6 are connected together.
14

Table 2.1: iPump 6400 connector details

Signal Description
950 to 2150 MHz RF carrier
from antenna LNB
ASI input signal
Audio output
Audio output
Video output
10/100baseT Ethernet
Contact closure/opening in
and out
100-to-120 Vac @60 Hz or
200-to-240 Vac @ 50 Hz
Optional Decoder with Digital Output
Pins 1 and 2 are normally open and are closed during an
!"
Pins 1 and 6 are normally closed and are open during an
!"
Pins 3 and 8 on the DB-9 are normally open and may be closed by command from
!"
Pin 5 is the local, user input (0=trigger).
!"
800009-01 Rev. J
Additional Information
A extension cable is shipped already
attached to the RF IN port to allow easier
access for attaching your RF input.
Only on s with the ASI input
iPump 6400
option.
A 1/8-to-RCA adapter is shipped with your
(one for each active audio
iPump 6400
decoder).
Can be "slaved" to decoder 1 or decoder 2
A Mini-DIN4-to-RCA adapter is shipped with
your . Units equipped with the
iPump 6400
optional, professional 4:2:2 decoders will
have a female BNC connector.
Autosensing; see pinout detail in
iPump 6400 LAN connector pin
on page 15
functions
See pinout detail in
Table 2.2: iPump 6400
Alarm connector pin functions
page 15
Autoswitching
on page 15 if your
iPump 6400
iPump 6400
iPump 6400
Table 2.3:
on
is equipped
alarm.
alarm.
.
Compel
www.wegener.com