Troubleshooting; Error Messages - Vari Lite VL1000 ERS Luminaire User Manual

❋
VARI LITE® - VL1000™ ERS L

Troubleshooting

Error Messages

If a problem occurs during luminaire calibration, at the end of the calibration sequence the Menu
Display will cycle through any applicable error message(s) until the end of the list is reached. To
review the error messages again, it will be necessary to access them using the Status function.
To access error messages:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Fixture appears. Press [Enter].
Step 3. Press [Up]/ [Down] arrows to access Status. Press [Enter]. (Display will now scroll
through any error messages or display OK if no errors.)
Pan/Encoder/Fail
Tilt/Encoder/Fail
Index/No Sens
Rot Gobo/No Sens
Lamp/Strike/Fail
68
U
UMINAIRE
Display
OK
Pan/No Sens
Tilt/No Sens
' M
SER S ANUAL
Table A-1: Error Messages
Message...
No Errors Found
Pan sensor not found.
Pan encoder failure.
Tilt sensor not found.
Tilt encoder failure.
Gobo Index sensor not found.
Rotating Gobo sensor not found.
Lamp strike failure.
05-Oct-2007 02. 96 63. 000 1 G