Addressing; Program Starting Address; Program Starting Address Without Calibrating - Vari Lite VL1000 ERS Luminaire User Manual

❋
VARI LITE® - VL1000™ ERS L

Addressing

Program Starting Address

The DMX starting address is entered using the Menu Display. This address will be retained even if the
power is removed.
Note: Refer to
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
To program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. DMX will appear. Press [Enter].
Step 4. Press [Up] / [Down] arrows to enter starting address.
Step 5. Press [Enter] to set.

Program Starting Address Without Calibrating

It is possible to bypass the calibration sequence and go directly to the Menu Display programming in
order to pre-program an address setting.
To program starting address without calibrating luminaire:
• While powering up luminaire, press and hold [Menu]. Program address as in
Address
• Release when display reads ":"
Note: The luminaire will require a reset to restore control.
32
U
UMINAIRE SER
Chapter 4: Menu System
above.
' M
S ANUAL
for detailed instructions on menu functions.
05-Oct-2007
Program Starting
02. 96 63. 000 1 G