Installation Procedures; Installing Lamp (Incandescent Models) - Vari Lite VL1000 ERS Luminaire User Manual

❋
VARI LITE® - VL1000™ ERS L

Installation Procedures

Installing Lamp (Incandescent Models)

In the event the lamp was packed separately during shipment, it will be necessary to install before use.
WARNING: Ensure that power is removed from luminaire when installing lamp.
CAUTION: Wear cotton gloves or other covering while installing lamp. Touching lamp glass with
bare fingers will leave oil and may cause the lamp to explode or reduce lamp life. If touched, use
alcohol and cotton cloth to thoroughly clean glass portion of lamp.
To install incandescent lamp:
Step 1. Ensure power is removed from luminaire.
Step 2. At backcap, gradually loosen two 10-32x2-3/8" PPSS black screws
at a time until backcap is free. (Screws must be alternately loosened to prevent one side from
locking up.)
Backcap
Interior View
18
U
UMINAIRE SER
Rear Head
Assembly
Align when
re-installing
CAUTION:
Alignment Hole (2)
Figure 2-4: Removing Incandescent Backcap
05-Oct-2007
' M
S ANUAL
Alignment Stud (2)
Holes and studs MUST be
aligned when re-installing.
(Figure 2-4) a few turns
Do not touch lamp
CAUTION: with bare fingers.
Backcap
10-32x2-3/8 PPSS
Black Screws (captive)
- loosen each gradually
02. 96 63. 000 1 G