Standard Power Up Procedure - Vari Lite VL1000 ERS Luminaire User Manual

Standard Power Up Procedure

Use this procedure when powering up a luminaire that has already been configured. (Refer to
Up and Configuration Overview" on page
Note: Refer to
CAUTION: Before applying power, be sure the luminaire is hung or positioned so that the head and
yoke can move freely without restriction.
To power up luminaire:
Step 1. At each luminaire, apply power by switching on power source. Luminaire will display
Starting for 10-15 seconds, and then automatically step through the following procedure:
a. For Arc lamps:
b. For Incandescent lamps:
02. 96 63. 000 1 G
Chapter 4: Menu System
1) If Lamp Power-Up State is set to Lamp On, lamp will strike (ignite).
2) Luminaire will cycle through calibration and stop at "home" position.
3) If Lamp Power-Up State is set to Cal On, lamp will strike (ignite) at end of
calibration sequence.
1) Luminaire will cycle through calibration and stop at "home" position.
I
NSTALLATION
28.)
for detailed instructions on menu functions.
05-Oct-2007
2
: P U
OWERING P
"Power-
29