Setting Up The Mobiletouch Wireless Controller - Intellitouch Pool and Spa Control System Installation Manual

Setting up the MobileTouch Wireless Controller

The following describes how to assign the MobileTouch wireless controller a communication address
for the first time and to add a MobileTouch controller to a system with a controller already installed.
To manually setup a MobileTouch wireless controller:
1. On the Outdoor Control Panel, press the Reset button.
2.
First Time MobileTouch install:
seconds then press the "F" Filter button. For model i10+3 press the "P" Pool Filter Pump
button.
Add a MobileTouch with existing MobileTouch installed:
lit (solid). Wait a few seconds then press the "V" button or "1" button.
3. The three red System Control LEDs and the auxiliary button LEDs will begin cycling. Wait until
the LEDs stop cycling. The three System Control LEDs will start to blink on and off. The system
is ready to enable the MobileTouch wireless controller. Continue with step 4.
Go to the Advanced screen.
Getting There
MENU SETUP ADVANCED
4. From the MobileTouch controller Advanced
screen, press the lower buttons 2 and 4 at
the same time. The Service Personnel screen
will be displayed.
The three red System Control LEDs will be lit (solid). Wait a few
Note: Press V or 1 button to add a MobileTouch
controller with existing MobileTouch controller(s)
already installed.
Three System
Control LEDs
F button
(i5+3, i5S+3 i7+3,
i9+3S, i9+3D)
P button (i10+3D)
The three red System Control LEDs will be
Auxiliary LEDs
Press button 2 and 4 at the same time
to access the Service Personnel screen
IntelliTouch Personality Kit Installation Guide
Reset button
29