Installing The Indoor Control Panel; Drill Control Panel Wall Mounting Holes - Intellitouch Pool and Spa Control System Installation Manual

22

Installing the Indoor Control Panel

The Indoor Control Panel controls pool, spa, lights and other functions of the IntelliTouch system
from inside the home or a sheltered area. Select a convenient wall location inside the house or
other weather-protected area for mounting the Control Panel.

Drill Control Panel Wall Mounting Holes

To drill the control panel mounting holes:
1. The Control Panel is 5-¾ in. wide. Using the cutout template below, mark the three screw
locations on the wall for the mounting holes. Drill the three mounting holes. If the screws
are not being screwed into studs, drill 3/16 in. holes and insert wall anchors (included in the
kit) as required.
2. Drill a hole ¼ in. within the gray area shown in the template for the communication cable to
feed through.
IntelliTouch Personality Kit Installation Guide
Edge of Control Panel
DRILL HOLE FOR
COMMUNICATION CABLE
ANYWHERE IN SHADED AREA
3/16" Hole for Plastic Anchor
Edge of Control Panel
Indoor Control Panel Template
Flathead Screw & Sheave
3/16" Hole for Plastic Anchor
3/16" Hole for Plastic Anchor