Installing The Outdoor Control Panel - Intellitouch Pool and Spa Control System Installation Manual

16

Installing the Outdoor Control Panel

The Outdoor Control Panel includes a motherboard and Personality board. The Personality board
is mounted on top of the Motherboard which mounts on the back of the Outdoor Control Panel.
The control panel installs in the top part of the Power/Load Center enclosure. The Power/Load
Center receives control inputs from the Personality board and distributes high voltage power to
Pentair Valve Actuators (PVA), control pumps, lights, and heater operations. The IntelliTouch remote
Indoor Control Panel also controls these and other functions, such as pool and spa lights.
To install the Outdoor Control Panel:
1. Unlatch the front door spring latches, and open the front door of the Power/Load Center.
2. Remove the screws securing the high voltage cover-panel, and remove it from the
enclosure.
3. Remove the Outdoor Control Panel from the Personality Kit and its packaging.
4. Mount the Outdoor Control Panel in the top part of the Power/Load Center. Secure the lower
edge of the control panel with the two retaining screws. Once secured, the Control Panel
can hinge out and down to access the Personality board for low voltage connections.
5. When finished with the low voltage connections on the Personality board, close the hinged
control panel and secure it with the two access screws.
6. Install the cover-panel and secure it with the two screws.
7. Close the front door of the Power/Load Center. Fasten the two spring latches.
Access screw
Cover-panel screw
(Cover-panel not shown)
Retaining screw
IntelliTouch Personality Kit Installation Guide
Power Center
Outdoor Control Panel
Access screw
Cover-panel
screw
Retaining screw