Installing Auxiliary Relays - Intellitouch Pool and Spa Control System Installation Manual

18

Installing Auxiliary Relays

Install additional axillary relays as needed. Depending on the Personality Kit there may be as many
as five additional relays.
To install a relay:
1. At the Power/Load Center, install the relays below the pre-installed relays. Secure in place
with two retaining screws.
2. Route the relay cable plug up through the holes into the high voltage compartment to the
Personality board.
3. Insert each auxiliary relay plug into the one of the two-pin sockets, beginning with AUX5,
AUX6, AUX7 and AUX8 on the Personality board. For wiring details, refer to the System
Wiring Diagrams on pages 32 and 33.
Note: Install the optional Two-Speed Pump relay (P/N 520198) cable plug into the 2SPD
two-pin socket on the Personality board. For installation and operation information, refer to
the Two-Speed Relay User's Guide (P/N 520210).
Personality Board
Relay Retaining
IntelliTouch Personality Kit Installation Guide
Screws
Optional Relays (3x)