Intellitouch Pool and Spa Control System Installation Manual page 31

4. Strip the leads of the communication cable wires ¼ in. Insert the wires into the screw
terminals (provided in the Personality Kit). Make sure to match the color-coding of the wires
(see front of circuit board). An optional cable clip feature has been built into the back plate to
help guide the communication cable.
5. Insert the screw terminal connector onto the circuit board socket.
6. Mount the control panel on the wall. Slide the control panel back plate over the mounting
sheave and slide down. Rotate back plate as necessary to make level. The bottom mounting
holes should be visible through cutouts in the controller board.
7. Feed the cable back into the wall so that the remainder left outside the wall fits behind the
back plate.
8. Install the pan head screws into the wall to secure the back plate.
9. Mount the control panel cover over back plate and snap in place to secure. Remove the
clear protective plastic sheet from the control panel LCD.
1 GND BLACK
2 -D
3 +D YELLOW
4 15V
Screw Terminal
Connector
GREEN
RED
Indoor Control Panel (rear view)
IntelliTouch Personality Kit Installation Guide
25