Connecting The Transceiver To The Personality Board; Using The Mobiletouch Wireless Controller - Intellitouch Pool and Spa Control System Installation Manual

28

Connecting the Transceiver to the Personality Board

To connect the Transceiver Module cable:
1. CAUTION - Switch the main power off at the Load Center or Power Center.
2. At the Load Center or Power Center, route the Transceiver module cable up through the low
voltage raceway to the Personality board. To access the Personality board, refer to Installing
the Outdoor Control Panel, page 16.
3. Strip back the cable conductors ¼ inch. Insert the wires into the screw terminals (provided
in the Personality Kit). Secure the wires with the screws. Make sure to match the color-
coding of the wires: GND = Black, Green = -DT, Yellow = +DT, and Red = +15
4. Insert the screw terminal connector onto either of the COM PORTS (J7 and J8) connectors
located on the left side of the Personality board. For wiring details, refer to the Wiring
Diagrams for models i5, i7+3, and i9+3, page 32 and 33.
Note: Multiple wires may be inserted into a single screw terminal.
Personality Board (Left-side)

Using the MobileTouch Wireless Controller

Do not leave the MobileTouch wireless controller in direct sunlight for extended periods of time.
If the control panel LCD screen darkens, place it in the shade for five minutes or until the screen
returns to normal before using. Do not adjust the contrast, the screen will become too light to see
when it cools down to its normal operating temperature.
WARNING Do not plug in the cradle AC adapter into an AC wall outlet power source within five
(5) feet of the pool and spa. Canadian installations require a minimum of three meters from pool
water. Do not recharge outdoors.
CAUTION The hand-held LCD control panel is NOT intended to be submersible. Remove unit
immediately if dropped in water.
IntelliTouch Personality Kit Installation Guide
BLK
GRN
YEL
RED