Installation Steps Summary; Tools Required - Intellitouch Pool and Spa Control System Installation Manual

Pool and spa control system personality kit
Hide thumbs Also See for Pool and Spa Control System:
Table of Contents

Advertisement

8

Installation Steps Summary

Note: The following installation instructions assume that the Load Center or Power Center is
installed at the equipment pad. For Load Center and Power Center installation instructions, refer to
the Load Center and Power Center Installation Guide (P/N 520100).
The recommended installation steps for the Personality Kit parts are as follows:
1
Install the Outdoor Control Panel (page 16): Install the Personality board in the Load Center
or Power Center. Also, review the high voltage connection locations in the Power/Load Center.
2
Connect pre-installed relays (page 17): Connect the relay plugs to the Personality board.
The four relays are pre-installed in the Power/Load Center.
Install auxiliary relays (page 18): Install and connect the relay(s). The number of relays
3
included in the Personality Kit depend on the Outdoor Control Panel model (i5, i5S (none),
i7+3 (Qty. 2), i9+3, i9+3S (Qty. 4), i10+3D (Qty. 5).
Install Valve Actuators (page 19): Install the valve actuators on the valve assembly and
4
connect to the Personality board.
5
Install Temperature Sensors (page 20): Install the water and air sensors and connect the
cable plugs to the Personality board.
Install Heat Thermostat (page 21): Connect the heater thermostat cable plug to the Personality
6
board.
7
Connect the Transformer (page 21): Connect the transformer cable plug to the Personality
board.
8
Install the Indoor Control Panel (page 22): Wall-mount the Indoor Control Panel and connect
to the Personality board.
9
Install the MobileTouch Wireless Control Panel (page 26): Mount the transceiver and
connect to the Personality board.
10
Affixing the System Wiring Diagram Label (page 31): Affix the wiring diagram on the inside of
the front door of the Power/Load Center (for models i5S, i9+3S, i10+3D only).

Tools required

3/16 in. diameter drill (for mounting Indoor Control Panel).
5/16 in. diameter drill (for mounting Water Temperature Sensor).
IntelliTouch Personality Kit Installation Guide

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents