Connecting The Pre-Installed Relays - Intellitouch Pool and Spa Control System Installation Manual

Connecting the Pre-Installed Relays

There are five pre-installed relays in the Load/Power Center. To connect the pre-installed relay cable
plugs to the Personality board:
• Route the power relay cable plugs up through the high voltage compartment to the
Personality Board. Insert the plug into the two-pin sockets, beginning with FLTR PUMP, then
AUX1, AUX2, AUX3, and AUX4. For the two-pin socket locations, refer to the diagram
shown below and the System Wiring Diagrams on pages 32 and 33.
• Dual Equipment: Pool and Spa with Dual Sets of Equipment – The IntelliTouch i10+3D
(P/N 520510) is designed to operate two sets of pool equipment. Each set of a equipment (Pool or
Spa) can control one temperature setting. This IntelliTouch Personality Kit can control up to 10 pumps
and/or lighting circuits, plus two heater circuits. The Personality Kit includes, eight auxiliary circuits
plus a filter pump.
• Single Equipment: Pool Only or Spa Only Applications – The IntelliTouch i5S+3 (P/N 520506) and i9+3S
provide advanced automation for a single body of water. The i5S+3 Personality Kits includes four auxiliary
circuits plus filter pump operation. Five relays are included in the Load Center. The i9+3S (P/N 520508)
Personality Kits includes eight auxiliary circuits plus filter pump operation and the +3 option (create a Feature
Macro circuit for valve actuators without using an existing output aux circuit). Four relays are included in the
kit and five in the Load Center. You can create a Feature circuit for valve actuators without using an existing
output auxiliary circuit, and special light functions for color lighting. This model also allows HI-TEMP and LO-
TEMP settings.
FLTR PUMP,
AUX1, AUX2,
AUX3, AUX4
Personality
Feed each relay
cable plug up
through holes
Board
IntelliTouch Personality Kit Installation Guide
17