Steel Heel Holder Bracket - LifeGear 75118 Inversion table Owner's Manual

3
31
16
27
9
31
7
27
11
7
STEP 5:
Slide the Rod (9) through the large round hole on the side of the Adjustable Boom (3), and secure
the Rod (9) on the Adjustable Boom (3) with one M6x47 Hex Head Bolt (11), one M6 Lock Nut (16),
and two Ø 16xØ 6.5x1.0 Washers (27). Slide one Steel Heel Holder Bracket (7) and one Rubber Heel
Holder (31) onto one end of the Rod (9) until the lock tooth is wedged into the slot in the Rod (9) as
shown in small figure. Use the same procedure to attach the other Steel Heel Holder Bracket (7) and
Rubber Heel Holder (31) onto the other end of the Rod (9).
Note: Make sure the lock teeth are wedged into the slots in the Rod (9) to lock the Steel Heel Holder
Brackets (7) and Rubber Heel Holders (31) in place before use.
3
40
13
39
13
15
STEP 6:
Slide the Foot Bar (39) into the bottom of the Adjustable Boom (3) and align two of the holes on
the Foot Bar (39) with two holes on the Adjustable Boom (3). Secure the Foot Bar (39) in place
using two M8x50 Hex Head Bolts (40), two M8 Lock Nuts (15), and four Ø 20xØ 8.5x1.5 Washers (13).
10