For 1-Way Air Discharge High-Ceiling Cassette Type (Ld Type) - Sanyo SPW-CR365GXH56 Technical Data Manual

2. Wireless Remote Controller
For 1-Way Air Discharge
High-Ceiling Cassette Type (LD Type)
2-7. Installing the Receiver Unit
(1) Push the cover tabs outwards, and pull the cover off
toward the front side of the panel. (Fig. 3-11)
(2) Pass the lead wire through the panel, then install the
receiver into the panel hole.
(3) Press the receiver lead wire into the rib along the
reverse side of the panel, and pass the wire through
the notch. (Fig. 3-12)
(4) Install the panel onto the indoor unit.
(5) Take the lead wire that extends from the panel and
fasten it to the top surface of the indoor unit using a
clamp. (Fig. 3-13)
(6) Use the supplied clamp on the fan casing latch to
fasten the lead wire to the fan casing. Pull the lead
wire through the hole at the bottom of the electrical
component box, and connect the wire to the remote
controller terminal plate. (Fig. 3-14)
NOTE
G Do not run the receiver lead wire together with the
power cable or other wiring. Doing so may result in
malfunction.
G Fasten the lead wire securely so that it does not
become caught in the fan.
G If electrical noise occurs in the unit power, a noise fil-
ter must be installed or other suitable measures
taken.
* For information on system wiring and conducting a
test run, refer to Section 4 "Electrical Wiring" and
Section 7 "Test Run" of the Installation Instructions.
Pull off toward the front side.
Push in
the lead wire.
Panel
Fan casing
Fig. 3-14
3 - 13
Control of Mini ECO-i SYSTEM
Spread
Spread
Fig. 3-11
Receiver
Rib
Notch
Fig. 3-12 Reverse side of panel
Clamp
Fig. 3-13
Fasten using
the supplied clamp
on the fan casing
latch.
Cover
3