Optional Distribution Joint Kit; Optional Ball Valve Kit - Sanyo SPW-CR365GXH56 Technical Data Manual

2. System Design

2-14. Optional Distribution Joint Kit

See the installation instructions packaged with the distribution joint kit for the installation procedure.
Table 2-11
Model name
APR-RP160AG
APR-RP160AG
Use: For indoor unit (Capacity after distribution joint is 22.4 kW or less.)
2
• When creating a tube of diameter G,
use a tube cutter and cut between F
and H. Cut at a point as close to H
as possible.
Table 2-12 Dimension for Connections of Each Part
Position A
Dimension –

2-15. Optional Ball Valve Kit

Table 2-13
Model No.
BV-RXP160AG
BV-RXP56AG
NOTE
1. Because the diameter of this ball valve is approximately the same as the inner diameter of the connecting
copper tube, correction for pressure loss is not necessary.
2. Airtightness must be 3.6 MPa or more.
It is recommended that the ball valve is installed at each outdoor unit (gas tube and liquid tube), in order to
prevent refrigerant from being released into the atmosphere if the outdoor unit is eventually replaced.
Cooling capacity after distribution
22.4 kW or less
Example: (F below indicates inner diameter.
B C
– –
Valve connecting tube size (mm)
Gas tube Liquid tube
15.88 9.52
12.7 6.35
Remarks
For indoor unit
F below indicates outer diameter.)
Gas tube
210 55
F
F F
J
F GH
HG
F
F
G
145
H
Insulator Insulator
D E F
– – ø19.05
Indoor unit where used
Total capacity of indoor units
after the valve
16.0 kW or less
5.6 kW or less
2 - 22
Design of Mini ECO-i SYSTEM
Liquid tube
185 50
H H
I J
I
H
I
J
135
G H
ø15.88 ø12.7 ø9.52
Unit: mm
I J
ø6.35