Accessories; Wiring The Receiver Unit; Precautions On Simultaneous Installation Of Wired Remote Controller And Wireless Remote Controller - Sanyo SPW-CR365GXH56 Technical Data Manual

2. Wireless Remote Controller

2-2. Accessories

No.
Receiver
1
unit
Remote
2
control unit
Remote
3
control holder

2-3. Wiring the Receiver Unit

G
Connection diagram
3
Remote controller
G
Connect the wire from the receiver unit to the
indoor unit remote controller terminal board. (The
wire has no polarity.)
2-4. Precautions on Simultaneous Installation of
Wired Remote Controller and Wireless
Remote Controller
By installing a wired remote controller, the wireless
remote controller kit can permit dual remote control
operation at the same time.
(Up to 2 units of remote controllers – a wireless kit
and a wired unit – can be installed.)
Dual remote control operation can control 1 or multiple
air conditioners using several remote controllers.
CAUTION
Parts Q'ty
1
1
1
Indoor unit
WHT
Terminal board BLK
G Be sure to determine the correct terminal num-
bers on the indoor unit when wiring the remote
controller. The remote controller will be dam-
aged if high voltage (such as 200 VAC) is
applied.
G
The wireless remote controller kit components
cannot be used for more than 1 indoor unit at a
time. (However, separate receiver units may be
used simultaneously.)
G
When a wireless remote controller kit and a
wired remote controller are used simultaneous-
ly, assign either the wireless remote controller
or the wired remote controller as the sub
remote controller unit.
No. Parts
AAA alkaline
4
battery
Tapping screw
5
4 × 16 mm
6
Clamp
Fastening screw
7
4 × 12 mm
Receiver PCB
CN001
2PWHT
3 - 10
Control of Mini ECO-i SYSTEM
Q'ty
2
2
1
1