I Switching The Room Temperature Sensors; I Connecting To A Ventilation Fan - Sanyo SPW-CR365GXH56 Technical Data Manual

3. Wired Remote Controller

I Switching the Room Temperature Sensors

Room temperature sensors are contained in the indoor unit and in the remote controller.
One or the other of the temperature sensors is used for operation. Normally, the indoor unit sensor is set; however,
the procedure below can be used to switch to the remote controller sensor.
(1) Press and hold the
NOTE
G
The unit No. that is initially displayed is the indoor unit address of the group control main unit.
G Do not press the
(2) Use the temperature setting
(3) Use the timer time
(4) Press the button. (The change is completed when the display stops blinking.)
(5) Press the button.
The unit returns to normal stop status. At this time, "Remote controller sensor" is displayed on the LCD.
NOTE
G If 2 remote controllers are used for control, this setting can be made from either the main or sub remote con-
troller. However, the temperature sensor that is used is the sensor in the main remote controller.
G
When group control is used, the remote controller sensor will not function unless the group address is set to the
address of the main indoor unit.
G
If both the remote sensor and remote controller are used, do not use the temperature sensor in the remote con-
troller.

I Connecting to a Ventilation Fan

If a commercially available ventilation fan or similar device is run from the ventilation fan output terminal (FAN
DRIVE: 2P (white), DC 12 V) (Note) on the indoor unit PCB, use the
change the settings.
(1) Press and hold the
NOTE
G The unit No. that is initially displayed is the indoor unit address of the group control main unit.
G
Do not press the
(2) Use the temperature setting
(3) Use the timer time
(4) Press the button. (The change is completed when the display stops blinking.)
(5) Press the button.
The unit returns to normal stop status. Press the
(Note) A special adapter (optional) is required to convert the signal for use at the no-voltage A contact.
+ + buttons for 4 seconds or longer.
button.
/ buttons to select item code 32.
/ buttons to change the setting data from 0000 to 0001.
+ + buttons for 4 seconds or longer.
button.
/ buttons to select item code 31.
/ buttons to change the setting data from 0000 to 0001.
Control of Mini ECO-i SYSTEM
button to enable fan operation and
button and check that "Fan" is displayed on the LCD display.
3 - 35
3