Installation Space; In Case Of Multiple Installations - Sanyo SPW-CR365GXH56 Technical Data Manual

3. Installation Instructions
3-2. Outdoor Unit
AVOID:
G heat sources, exhaust fans, etc. (Fig. 2-6)
G
damp, humid or uneven locations
DO:
G choose a place as cool as possible.
G
choose a place that is well ventilated and outside air temperature
does not exceed maximum 45°C constantly.
G
allow enough room around the unit for air intake/
2
exhaust and possible maintenance. (Fig. 2-7)
G use lug bolts or equal to bolt down unit, reducing vibration and noise.

Installation space

Distance between obstructions and the unit air inlet and outlet must be
as shown below.
More than 1 cm
*2
CAUTION

In case of multiple installations

provide a solid base (concrete block, 10 × 40 cm
G
beams or equal), a minimum of 15 cm above
ground level to reduce humidity and protect the unit
against possible water damage and decreased
service life. (Fig. 2-9)
G
use lug bolts or equal to bolt down unit, reducing
vibration and noise.
*3
Inlet side C
More than 1 cm
*4
Outlet side
More than
100 cm
*1
Fig. 2-7
G Concerning inlet-side distance "C" (Fig. 2-7)
The minimum for distance "C" is 15 cm if there are no obstructions on the outlet side
(wall *1 side) and *2 or *4 is not present. In all other cases, the minimum for distance
"C" is 20 cm.
G If the unit is installed with the outlet side facing wall *1, then there must be no obstruc-
tions on 2 of the remaining 3 sides: *2, *3, *4.
G
If wall *1 is on the outlet side (Fig. 2-7), or if obstructions are present on all 3 sides *2,
*3, and *4 (Fig. 2-7), then the minimum distance for "A" and "B" is 2 m (Fig. 2-9). Even
if there is no wall on the outlet side, a minimum of 100 cm is required.
Design of Mini ECO-i SYSTEM
Hot air
(Obstruction above unit)
Air direction chamber
(field supply)
*1
Anchor bolts
(4 pieces)
2 - 26
Exhaust fan
Heat source
Out-
door
unit
Fig. 2-6
B
A
Inlet side
More than 20 cm
(Obstruction on
inlet side)
(Ground)
Fig. 2-8
Fig. 2-9