Relationship Between Serial Numbers In The Device List On The Lu Operation Pane And Thunder 9500V Subsystem Models - HP StorageWorks User Manual

Table 12 System parameter settings (Thunder 9500V subsystems) (continued)
Pane name
Inquiry Setting
Port Type
Controller Option
Host Connection Mode
NOTE: When using the Thunder 9500V subsystem as an external disk array, the following versions are
recommended. If you use a 9500V subsystem whose version is earlier than the following versions, the
SATA drive's information might not be displayed correctly.
• For Thunder 9530V, Thunder 9520V, Thunder 9570V: version 0658 or later
• For Thunder 9580V, Thunder 9585V: version 1658 or later
Relationship between serial numbers in the Device list on the LU Operation pane and Thunder
9500V subsystem models
When the external disk array is a Thunder 9500V subsystem, you can identify the subsystem model from
the serial number displayed in the Serial column in the Device list on the LU Operation pane.
102 External Storage XP for the XP12000/XP10000
Parameter
Command Queuing Mode
Vendor ID
Product ID
ROM Microprogram Version
RAM Microprogram Version
WEB Title
Reset/LIP Mode
• Reset/LIP Mode (Signal)
• Reset/LIP Mode (Process)
• LIP Reset Mode
RS232C Error Information Outflow Mode
Write and verify mode
Host Connection Mode 1
Host Connection Mode 2
Parameter setting
Set this parameter to ON.
Keep this parameter as HITACHI (default),
and do not change.
Keep this parameter as DF600F (default),
and do not change.
You can either specify this parameter or
omit specifying this parameter.
You can either specify this parameter or
omit specifying this parameter.
You can either specify this parameter or
omit specifying this parameter.
You can either specify this parameter or
omit specifying this parameter.
You can either specify this parameter or
omit specifying this parameter.
You can either specify this parameter or
omit specifying this parameter.
You can either specify this parameter or
omit specifying this parameter.
Set this parameter to ON.
Set this parameter to Standard Mode.
Specify HISUP Mode.
NOTE: Do not specify any other
parameters.