Tray 2 Media Type Mismatch Error - Lexmark C93x Service Manual

Step
3
Check the sensor (transparency detect) for proper
operation.
1. Enter the Diagnostics Menu.
2. Select BASE SENSOR TESTS.
3. Select Media path.
4. Select Transparency detect
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
4
Check the sensor (transparency detect) for proper
connection.
Is the above component properly connected?
5
Perform a POR.
Does the error remain when the power is turned off/on?
6
Perform a POR.
Does the error remain when the power is turned off/on
again?

Tray 2 media type mismatch error

Step
1
Check the media tray assembly 2 for the correct media
type.
Does the above tray contain the correct type of media?
2 Check the media tray assembly 2 for the transparencies.
Does the media tray 1 assembly contain transparencies?
Check
Check
Yes
Go to step 5. Go to step 4.
Replace the Replace the
sensor connection.
(transparency
detect).
Go to "Sensor
(transparency
detect) removal"
on page 4-38.
Replace the lower Problem solved.
printer engine card
assembly.
"Lower
Go to
printer engine
card assembly
removal" on
page 4-82.
Replace the RIP Problem solved.
card assembly.
"RIP card
Go to
assembly
removal" on
page 4-75.
Yes
Go to step 2. Install the correct
media.
Ensure that the Go to step 3.
media tray
assembly is
supposed to be
configured for
transparencies or
replace them with
standard media.
Diagnostic information
5057-XXX
No
No
2-55