Measurement Cycle Test - Lexmark C93x Service Manual

Measurement cycle test

Step
1 Perform the Measurement cycle test.
1. Enter the Diagnostics Menu.
2. Select ENGINE ADJUST.
3. Select RegCon adjust
4. Select Measurement cycle
Does the above test pass?
2
Check the transfer belt unit assembly for damage.
Does above component show signs of damage on the
frame or on the belt?
3
Check the image density sensor assembly connection.
Is the above component properly connected?
4
Re-perform the Measurement cycle test again.
Does the above test pass?
Check Yes
Perform the Go to step 2.
"Control sensor
check".
"Control
See
sensor check" on
page 4-210.
Replace the Go to step 3.
transfer belt unit
assembly.
"Transfer
See
belt unit
assembly
removal" on
page 4-16.
Replace the image Replace the
density sensor connection.
assembly.
See "Image
density sensor
assembly
removal" on
page 4-44.
Perform the Contact next level
"Control sensor of support.
check".
Go to"Control
sensor check" on
page 4-210.
Repair information
5057-XXX
No
4-209