5057-XXX
Step
5
Check the sensor (tray 2 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Select INPUT TRAY TESTS.
3. Select Sensor test.
4. Select Tray 2.
5. Select Feed-out.
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
6
Check the sensor (tray 2 feed-out) for proper connection.
Is the above component properly connected?
7
Check the MPF/transport drive motor for proper operation.
1. Enter the Diagnostics Menu.
2. Select MOTOR TESTS.
3. Select Printer motor tests.
4. Select MPF/transport drive motor.
Does the above component operate properly?
8
Check the MPF/transport drive motor for proper connection.
Is the above component properly connected?
9
Perform a print test.
Does the error continue?
243.00 Sensor (tray 3 feed-out) late jam
Step
1
Check the media condition.
Is the media in the tray crumpled or damaged?
2
Check the media size setup.
Does the media size, in use, match the size set for
tray 3?
2-40
Printer Service Manual
Check
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Check
Yes
Go to step 7.
Go to step 6.
Replace the
Replace the
sensor (tray 2
connection.
feed-out).
Go to step 9.
Skip to step 8.
Replace the MPF /
Replace the
transport drive
connection.
motor .
"MPF /
Go to
transport drive
motor assembly
removal" on
page
4-106.
Replace the lower
Problem solved.
printer engine card
assembly.
Go to
"Lower
printer engine
card assembly
removal" on
page
4-82.
Yes
Replace the
Go to step 2.
damaged media with
new.
Go to step 3.
Replace the media,
or change the media
size setup.
No
No