Table of Contents
Advertisement
5057-XXX
To change this setting:
1. Select Paper Prompts from the Configuration Menu.
2. Make your selection and press
3. To exit this screen without changing the setting's value, select Back.
Envelope Prompts
This setting controls the tray the user is directed to refill when a specific envelope size is out. The selections are
Auto (default), MP Feeder, and Manual Env.
To change the value of this setting:
1. Select Env Prompts from the Configuration Menu.
2. Make your selection and press
3. To exit this screen without changing the setting's value, select Back.
Font Sharpening
This setting allows you to set a text point size below which the high-frequency screens are used when printing
font data. For example, at the default 24, all text in font sizes 24 and less will use the high frequency screens.
The values for this setting range from 0 to 150.
To change this setting:
1. Select Font Sharpening from the Configuration Menu.
2. Press
to increase the value or
3. Press
to save the change.
This setting affects the PostScript, PCL, PDF, and XL emulators.
This function is not supported when the device generates output at 600 dpi resolution.
Require Standby
This setting determines if the Standby Mode is On or Off. The default is On.
To change this setting:
1. Select Require Standby from the Configuration Menu.
2. Select Back to cancel and return to the Configuration Menu.
3. Press
to submit the change.
If Standby Mode is on, the printer begins functioning in Standby Mode when it remains idle for an amount of
time. The Standby Mode enables the printer:
•
To consume less energy than when operating in normal mode but not as little as when operating in Power
Saver
•
To return to the Ready state more quickly than when operating in Power Saver
Short Edge Printing
The default printing orientation is long edge. This setting allows you to enable or prohibit short edge fed paper. If
the setting Disabled (default) is selected, letter and A4 paper can only be fed long edge. If they are fed short
edge, a prompt will ask you to use the correct paper size. When the setting is Enabled, you can feed paper
either long edge or short edge.
3-28
Printer Service Manual
.
.
to decrease the value.
Advertisement
Chapters
Table of Contents
