Table of Contents
Advertisement
Transfer belt steering motor removal
1. Remove the front left cover. See
2. Remove the waste toner cartridge cover. See
3. Remove the waste toner cartridge sensor assembly. See
on page
4-39.
4. Remove the sensor (waste toner cartridge full). See
page
4-40.
5. Remove the inner cover assembly. See
6. Disconnect the connector transfer belt steering motor (A).
7. Remove the three screws securing the transfer belt steering belt motor (A) to the machine.
8. Remove the transfer belt steering motor (A).
CMY erase lamp assembly removal
Warning: Ensure the transfer belt unit assembly is removed, or damage will occur.
1. Remove the printer front door assembly. See
2. Remove the front left cover. See
3. Remove the waste toner cartridge cover. See
4. Remove the waste toner cartridge sensor assembly. See
on page
4-39.
5. Remove the sensor (waste toner cartridge full). See
page 4-40
6. Remove the inner cover. See
7. Raise the transfer belt lift handle (A) to its upper-most position.
8. Disconnect the connector from the appropriate CMY erase lamp assembly (B).
9. Release the harness from the clamp.
10. Remove the screw securing the appropriate bracket (C) to the machine.
11. Lower the transfer belt lift handle (A) to its lower-most position.
Note: Access to the rear mounting hook on the CMY erase lamp (B) can be gained by reaching into the transfer
belt unit opening from the right side of the machine.
"Front left cover removal" on page
"Waste toner cartridge cover removal" on page
"Sensor (waste toner cartridge full) removal" on
"Inner cover removal" on page
"Printer front door assembly removal" on page
"Front left cover removal" on page
"Waste toner cartridge cover removal" on page
"Sensor (waste toner cartridge full) removal" on
"Inner cover removal" on page
4-9.
"Waste toner cartridge sensor assembly removal"
4-42.
A
4-9.
"Waste toner cartridge sensor assembly removal"
4-42.
Repair information
5057-XXX
4-39.
4-3.
4-39.
4-65
Advertisement
Chapters
Table of Contents
