Changing The Transfer Gear Oil; Checking The Clutch Fluid Level - Yamaha XV19SW Service Manual

Transfer gear oil check bolt
8 Nm (0.8 m·kg, 5.8 ft·lb)
EAS20850

CHANGING THE TRANSFER GEAR OIL

1. Remove:
• Muffler
• Exhaust pipes
Refer to "ENGINE REMOVAL" on page 5-1.
2. Place a container under the transfer gear oil
drain bolt.
3. Remove:
• Straight plug "1"
• Transfer gear oil drain bolt "2"
2
1
4. Drain:
• Transfer gear oil
(completely from the transfer gear case)
5. Check:
• Transfer gear oil drain bolt gasket
Damage → Replace.
6. Install:
• Transfer gear oil drain bolt
(along with the gasket)
Transfer gear oil drain bolt
18 Nm (1.8 m·kg, 13 ft·lb)
7. Fill:
• Transfer gear case
(with the specified amount of the recom-
mended transfer gear oil)
Quantity
0.55 L (0.58 US qt) (0.48 Imp.qt)
Quantity (disassembled)
0.60 L (0.63 US qt) (0.53 Imp.qt)
8. Install:
• Straight plug
9. Check:
• Transfer gear oil level
Refer to "CHECKING THE TRANSFER
GEAR OIL LEVEL" on page 3-13.
10.Install:
• Exhaust pipes
• Muffler
Refer to "ENGINE REMOVAL" on page 5-1.
EAS20890

CHECKING THE CLUTCH FLUID LEVEL

1. Stand the vehicle on a level surface.
NOTE:
Place the vehicle on a suitable stand.
2. Check:
• Clutch fluid level
Below the minimum level mark "a" → Add the
recommended clutch fluid to the proper level.
Recommended clutch fluid
Brake fluid DOT 4
EWA13370
WARNING
• Use only the designated clutch fluid. Other
clutch fluids may cause the rubber seals to
deteriorate, causing leakage and poor
clutch performance.
3-14
ENGINE