Yamaha XV19SW Service Manual page 193

2
8. Install:
• Oil seal clip "1"
NOTE:
Adjust the oil seal clip so that it fits into the outer
tube's groove.
9. Install:
• Dust seal "1"
(with the fork seal driver weight "2")
Fork seal driver
90890-01442
Adjustable fork seal driver (36–46
mm)
YM-01442
10.Fill:
• Front fork leg
(with the specified amount of the recom-
mended fork oil)
1
4-67
Quantity
571.0 cm³ (19.31 US oz) (20.10
Imp.oz)
Recommended oil
Fork oil 10WT
11.Measure:
• Front fork leg oil level "a"
(from the top of the inner tube, with the outer
tube fully compressed and without the fork
spring)
Out of specification → Correct.
Level
124.0 mm (4.88 in)
NOTE:
• While filling the front fork leg, keep it upright.
• After filling, slowly pump the front fork leg up
and down to distribute the fork oil.
12.Install:
• Spring "1"
• Spring seat "2"
• Spacer
• Cap bolt
(with O-ring)
NOTE:
• Install the spring with the smaller pitch facing
up.
• Before installing the cap bolt, lubricate its O-
ring with grease.
• Temporarily tighten the cap bolt.
FRONT FORK