Yamaha XV19SW Service Manual page 184

EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
L LLL L LLL L L LLL L L LLL L
6. Install:
• Left handlebar switch "1"
NOTE:
Align the projection "a" on the left handlebar
switch with the hole "b" in the handlebar.
a
7. Install:
• Clutch master cylinder "1"
• Clutch master cylinder holder "2"
Clutch master cylinder holder
bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
NOTE:
• Align the end of the clutch master cylinder
holder with the punch mark "a" on the handle-
bar.
• First tighten the rear bolt, then the front bolt.
8. Install:
• Throttle grip
• Throttle cables
• Right handlebar switch "1"
• Grip end "2"
NOTE:
• Align the projection "a" on the right handlebar
switch with the hole "b" in the handlebar.
L LLL L L LLL L LLL
b
1
1
a
2
4-58
• There should be 1–3 mm (0.04–0.12 in) of
clearance "c" between the throttle grip and the
grip end.
b
1
9. Install:
• Front brake master cylinder "1"
• Front brake master cylinder holder "2"
Front brake master cylinder hold-
er bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
NOTE:
• Align the end of the front brake master cylinder
holder with the punch mark "a" on the handle-
bar.
• First tighten the rear bolt, then the front bolt.
1
a
10.Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE CA-
BLE FREE PLAY" on page 3-8.
HANDLEBAR
a
c
2
2