Starting Circuit Cut-Off System Operation - Yamaha XV19SW Service Manual

EAS27180

STARTING CIRCUIT CUT-OFF SYSTEM OPERATION

If the engine stop switch is set to "
closed), the starter motor can only operate if at least one of the following conditions is met:
• The transmission is in neutral (the neutral switch circuit is closed).
• The clutch lever is pulled to the handlebar (the clutch switch circuit is closed) and the sidestand is up
(the sidestand switch circuit is closed).
The starting circuit cut-off relay prevents the starter motor from operating when neither of these condi-
tions has been met. In this instance, the starting circuit cut-off relay stays open so current cannot reach
the starter motor. When at least one of the above conditions has been met, the starting circuit cut-off
relay is closed and the engine can be started by pushing the start switch "
ELECTRIC STARTING SYSTEM
" and the main switch is turned "ON" (both switch circuits are
14
13
1
3
15
7
8
8
9
b
7-9
".
2
17
4
5
6
a
8
11 12
10
16