Removing The Front Brake Calipers; Disassembling The Front Brake Calipers - Yamaha XV19SW Service Manual

L LLL L LLL L L LLL L L LLL L
3. Install:
• Brake pad pin
• Brake pad clips
• Front brake caliper
Front brake caliper bolt
40 Nm (4.0 m·kg, 29 ft·lb)
4. Check:
• Brake fluid level
Below the minimum level mark "a" → Add the
recommended brake fluid to the proper level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-20.
5. Check:
• Brake lever operation
Soft or spongy feeling → Bleed the brake sys-
tem.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-22.
EAS22300

REMOVING THE FRONT BRAKE CALIPERS

The following procedure applies to both of the
brake calipers.
NOTE:
Before removing the brake caliper, drain the
brake fluid from the entire brake system.
1. Remove:
• Brake hose holder "1"
• Front brake hose union bolt "2"
• Copper washers "3"
L LLL L L LLL L LLL
4-38
FRONT BRAKE
• Front brake hose "4"
NOTE:
Put the end of the brake hose into a container
and pump out the brake fluid carefully.
2
3
EAS22350
DISASSEMBLING THE FRONT BRAKE
CALIPERS
The following procedure applies to both of the
brake calipers.
1. Remove:
• Brake caliper pistons "1"
• Brake caliper piston seals "2"
EW1D71001
WARNING
Do not loosen the bolts "3".
M MMM M MMM M M MMM M M MMM M
a. Blow compressed air into the brake hose joint
opening "a" to force out the pistons from the
brake caliper.
EWA13560
WARNING
• Cover the brake caliper pistons with a rag.
Be careful not to get injured when the pis-
tons are expelled from the brake caliper.
• Never try to pry out the brake caliper pis-
tons.
1
4
M MMM M M MMM M MMM