Adjusting The Throttle Cable Free Play - Yamaha XV19SW Service Manual

1
5
3
2
6. Install:
• Fuel tank
Refer to "FUEL TANK" on page 6-1.
7. Adjust:
• Throttle body synchronization
M MMM M MMM M M MMM M M MMM M
a. Start the engine and let it warm up for several
minutes, and then let it run at specified en-
gine idling speed.
Engine idling speed
850–950 r/min
b. With throttle body #1 as standard, adjust
throttle body #2 using the air screw "1" (for
throttle body #2).
NOTE:
• After each step, rev the engine two or three
times, each time for less than a second, and
check the synchronization again.
• If the air screw was removed, turn the screw
3/4 turn in and be sure to synchronize the throt-
tle body.
ECA14900
CAUTION:
Do not use the throttle valve adjusting
screws to adjust the throttle body synchroni-
zation.
Intake vacuum
31.3–35.3 kPa (9.3–10.4 inHg)
(235–265 mmHg)
4
6
2
1
M MMM M M MMM M MMM
1
3-8
NOTE:
The difference in vacuum pressure between two
throttle bodies should not exceed 1.33 kPa (10
mmHg).
L LLL L LLL L L LLL L L LLL L
8. Stop the engine and remove the measuring
equipment.
9. Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE CA-
BLE FREE PLAY" on page 3-8.
Throttle cable free play
4.0–6.0 mm (0.16–0.24 in)
10.Install:
• Fuel tank
Refer to "FUEL TANK" on page 6-1.
• Cylinder-#1 ignition coil cover
Refer to "ENGINE REMOVAL" on page 5-1.
• Rider seat bracket assembly
• Rider seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS20630
ADJUSTING THE THROTTLE CABLE FREE
PLAY
NOTE:
Prior to adjusting the throttle cable free play, the
engine idling speed and throttle body synchroni-
zation should be adjusted properly.
1. Check:
• Throttle cable free play "a"
Out of specification → Adjust.
Throttle cable free play
4.0–6.0 mm (0.16–0.24 in)
2. Adjust:
• Throttle cable free play
ENGINE
L LLL L L LLL L LLL
a