Yamaha XV19SW Service Manual page 300

• Install the middle drive gear "2" with its cham-
fered side facing "b" the transfer gear case.
• Install the middle driven shaft, middle drive
gear and primary chain at the same time.
• Align the splines on the middle drive gear with
the splines on the drive axle.
• Temporarily install the drive pulley nut onto the
middle driven shaft.
1
b
3. Install:
• Conical spring washer "1"
• Middle drive gear nut "2"
Middle drive gear nut
140 Nm (14.0 m·kg, 100 ft·lb)
NOTE:
• Lubricate the middle drive gear nut threads
and conical spring washer mating surfaces
with engine oil.
• Install the conical spring washer "1" with the
"OUT" mark "a" facing out.
• Stake the middle drive gear nut "2" at a cutout
"b" in the drive axle.
a
3
2
2
New
5-88
TRANSFER GEAR CASE
1
a
b
4. Remove:
• Drive pulley nut
2 New