Cosmetic Specifications - Dalsa 4M30 User Manual

8
•
•
•
•
•
•
•
•
•
•
•
•
Notes:
1.
2.
3.
4.
5.
6.
7.
8.

1.3 Cosmetic Specifications

Please note, for this section only, the following values are considered preliminary
information and subject to change without notice.
Sensor Cosmetic Specifications
The following table highlights the current cosmetic specifications for the DALSA sensor
used inside the Falcon 4M60 and 4M30 cameras. The monochrome sensor has 4
megapixels (2352 x 1728), global shuttering and is capable of 60 fps.
Sensor Cosmetic Specifications
Cosmetic Specification
Hot pixel defects
Single pixel defects
Clusters defects
Spot defects
Column defects
Row defects
03-032-20044-01
ssf 55 (55 frames per second rate).
set 2000 (2 millisecond exposure time).
sem 2 (Exposure mode 2) .
Full frame/window.
clm 16 (4 tap, 10 bit).
sot 320 (80 MHz camera link strobe).
efd 1 (Snapshot mode 1).
snd 1 (Number of fast frame dumps = 1).
Light Source: Broadband Quartz Halogen, 3250K (3050 to 3450), with a 750 nm cutoff
filter .
Ambient test temperature 25°C.
Average output 840 DN.
Flat field correction (FFC) turned on.
Measured at the front plate.
Based on output at 1023 DN.
Output over 10-90%.
Snapshot mode 0 allows for marginally higher frame rates.
Optical distance.
+12V consumes the least amount of power.
With FFC on. Responsivity is not calibrated when FCC is turned off.
Measured at half saturation.
Maximum Number of Defects
1
100
No limit (refer to the Note below)
1
0
0
Falcon 4M Camera Manual
DALSA