Table of Contents
Advertisement
3. Hardware Configuration
This chapter explains you the instructions of how to setup your system.
3.1
Installation Procedure
1. Turn off the power supply.
2. Insert the DIMM module (be careful with the orientation).
3. Insert all external cables for hard disk, floppy, keyboard, mouse, USB etc. except for
flat panel. A CRT monitor must be connected in order to change CMOS settings to
support flat panel.
4. Connect power supply to the board via the PWR1.
5. Turn on the power.
6. Enter the BIOS setup by pressing the delete key during boot up. Use the "LOAD BIOS
DEFAULTS" feature. The Integrated Peripheral Setup and the Standard CMOS
Setup Window must be entered and configured correctly to match the particular
system configuration.
7. If TFT panel display is to be utilised, make sure the panel voltage is correctly set
before connecting the display cable and turning on the power.
3.2
Safety Precautions
3.2.1
Warning!
Always completely disconnect the power cord from your chassis or power
cable from your board whenever you work with the hardware. Do not make
connections
be damaged by sudden power surges. Only experienced electronics
personnel should open the PC chassis.
3.2.2
Caution!
Always ground yourself to remove any static charge before touching the
board. Modern electronic devices are very sensitive to static electric
charges. As a safety precaution, use a grounding wrist strap at all times.
Place all electronic components in a static-dissipative surface or static-
shielded bag when they are not in the chassis.
while the power is on. Sensitive electronic components can
ECM-5716 Series User' s Manual 15
ECM-5716 Series
Advertisement
Table of Contents
