Hardware Monitor - Aaeon EMB-APL3 Manual

3.3.5

Hardware Monitor

Smart Fan Configuration
CPU Smart Fan Control [Disabled]
Allows you to enable or disable CPU Smart Fan Control. Configuration options:
[Enabled] [Disabled]
The following sub-items appear only when you set CPU Smart Fan Control to
[Enabled].
Fan Control Mode [Manual Mode]
Configuration options: [Manual Mode] [Thermal Cruise Mode] [Speed Cruise
Mode] [Smart Fan IV Mode]
The following item appears only when you set Fan Control Mode to [Manual
Mode].
PWM/DC Voltage Output [255]
Sets the voltage allocated for Fan Control. Input value range: [0~255]
The following items appear only when you set Fan Control Mode to [Thermal
Cruise Mode].
Temperature Source [CPUTIN]
Allows you to select the temperature source. Configuration options: [SYSTIN]
[CPUTIN] [AUXTIN0] [AUXTIN1] [AUXTIN2] [AUXTIN3] [SMBUSMASTER
0] [SMBUSMASTER 1] [SMBUSMASTER 2] [SMBUSMASTER 3]
[SMBUSMASTER 4] [SMBUSMASTER 5] [SMBUSMASTER 6]
[SMBUSMASTER 7] [PECI Agent 0] [PECI Agent 1] [PCH_CHIP_CPU_
MAX_TEMP] [PCH_CHIP_TEMP] [PCH_CPU_TEMP] [PCH_MCH_TEMP]
[PCH_DIM0_TEMP] [PCH_DIM1_TEMP] [PCH_DIM2_TEMP] [PCH_DIM3_
TEMP] [BYTE_TEMP]
Target Temperature [50]
Input value range: [0~127]
Tolerance of Temperature [0]
Input value range: [0~7]
Fan Out Start-Up Value [127]
Input value range: [0~255]
Fan Stop Duty [Down to 0]
[Down to 0]
[To Fan Out Stop Value] Uses the same value as Fan Out Stop Value.
Chapter 3: BIOS setup
Fan Out will decrease to 0 at most if necessary.
3-5