Table of Contents
Advertisement
User' s Manual
4.5.12
Supervisor / User Password Setting
You can set either supervisor or user password, or both of them. The differences between
are:
supervisor password: can enter and change the options of the setup menus.
user password: just can only enter but do not have the right to change the options of the
setup menus. When you select this function, the following message will appear at the
center of the screen to assist you in creating a password.
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The password
typed now will clear any previously entered password from CMOS memory. You will be
asked to confirm the password. Type the password again and press <Enter>. You may
also press <Esc> to abort the selection and not enter a password. To disable a password,
just press <Enter> when you are prompted to enter the password. A message will confirm
the password will be disabled. Once the password is disabled, the system will boot and
you can enter Setup freely.
PASSWORD DISABLED.
64 ECM-5716 Series User' s Manual
Advertisement
Table of Contents
