Table of Contents
Advertisement
User' s Manual
3.3
Socket 479 Processor
3.3.1
Installing Pentium M CPU
Align the processor pins with pin holes on the socket. Make sure that the notched
n
corner or dot mark (pin 1) of the CPU corresponds to the socket' s bevel end. Then
press the CPU gently until it fits into place. If this operation is not easy or smooth,
don' t do it forcibly. You need to check and rebuild the CPU pin uniformly.
Use a screw driver to revolve the screw till the processor chip is locked into the
n
socket.
Follow the installation guide of cooling fan or heat sink to mount it on CPU surface
n
and lock it on the socket 479.
Be sure to follow particular CPU speed and voltage type to adjust the jumper settings
n
properly.
3.3.2
Removing CPU
Unlock the cooling fan first.
n
Lift the lever of CPU socket outwards and upwards to the other end.
n
Carefully lift up the existing CPU to remove it from the socket.
n
Follow the steps of installing a CPU to change to another one or place handling bar
n
to close the opened socket.
3.4
Main Memory
ECM-5716 provides one 184-pin DDR SDRAM DIMM sockets to support DDR SDRAM.
The total maximum memory size is 1GB.
Watch out the contact and lock integrity of memory module with socket, it will influence
the system' s reliability. Follow the normal procedure to install your DDR SDRAM module
into the DIMM socket. Before locking the DIMM module, make sure that the memory
module has been completely inserted into the DIMM socket.
Note:
Please do not change any DDR SDRAM parameter in BIOS setup to increase your
system' s performance without acquiring technical information in advance.
16 ECM-5716 Series User' s Manual
Advertisement
Table of Contents
