Table of Contents
Advertisement
Troubleshooting
In rare cases, the camera may not operate correctly due to static
electricity. This can be remedied by taking the battery out and putting it
back in again. After these procedures are done, if the camera operates
correctly, it does not require any repairs.
We recommend checking the following items before contacting a service
center.
Problem
Battery is not
installed
The camera
Battery is not
does not turn
installed properly
on
The battery power
is low
The built-in flash
is charging
There is no
available space on
the SD Memory
The shutter
Card
cannot be
released
Recording
The lens aperture
ring is set to a
position other
than s
Cause
Check if a battery is installed.
Check the orientation of battery. Re-insert
battery according to the +/- symbols.
(p.49, p.50)
Replace with a charged battery or use
the optional AC adapter kit.
E blinks while the built-in flash is
charging. Wait until charging is finished.
Insert an SD Memory Card with available
space or delete unwanted images. (p.75,
p.193)
Wait until recording is finished.
Set the lens aperture ring to the s
position or select [Enable] in
[20. Using Aperture Ring] of the
[A Custom Setting 3] menu. (p.276)
Remedy
285
10
Advertisement
Table of Contents
