Table of Contents
Advertisement
258
Wireless Shooting Using a Combination of the Built-in Flash
and an External Flash Unit
Set the camera to wireless flash mode when using an external flash
in combination with the built-in flash.
1
Remove the external flash unit after the channel is set on
the camera, and place it at the desired location.
2
Set the camera's flash mode to r.
The camera is ready to take a picture.
The channel for the built-in flash is
displayed in the viewfinder.
3
Press the E button.
4
Confirm that both flashes are fully charged, and then take
a picture.
r is not available in the following situations.
• in C mode
• when the drive mode is set to [Remote Control (3 sec. delay)]
• when the lens aperture ring is set to a position other than s
9
You can change the built-in flash discharge method used in wireless mode.
Set in [16. Flash in Wireless Mode] of the [A Custom Setting 3] menu.
On
Discharges the built-in flash as a master flash. (default setting)
Off
Discharges the built-in flash as a control flash.
Wireless Mode
Wireless Mode
0.0
0.0
Cancel
Cancel
MENU
OK
OK
OK
Advertisement
Table of Contents
