Table of Contents
Advertisement
2
Press the four-way controller (5),
use the four-way controller (23)
to select a setting, and press
the 4 button.
3
Use the four-way controller (23) to select [Auto Align],
and use the four-way controller (45) to select O or P.
Uses Auto Align. Activates Shake Reduction according to the [Shake
O
Reduction] setting. (default setting)
Does not use Auto Align. Deactivates Shake Reduction.
P
4
Use the four-way controller (23) to select [Exposure Bracket
Value], and press the four-way controller (5).
5
Use the four-way controller (23) to set the range in which
to change the exposure, and press the 4 button.
Select from ±1 EV, ±2 EV (default setting) or ±3 EV.
6
Press the 3 button twice.
The camera is ready to take a series of pictures.
• The procedure of Step 2 can also be performed through the control panel.
• When both Shake Reduction and Auto Align are activated, take note of the
following points.
• Make sure to hold the camera firmly so that the composition of the picture does
not change while the three images are captured. If there is a great difference
of the composition between three images, Auto Align may not be possible.
• Images captured with HDR Capture are susceptible to camera shake and
blur. Be sure to set a higher shutter speed and a higher ISO sensitivity.
• When the sensitivity is set to [ISO AUTO], the sensitivity can be raised
more easily than normal.
• Auto Align may not be possible when lenses that have a focal length
exceeding 100 mm are used, or when the entire subject is checkered
or has a uniform surface.
• In Z (Night Scene HDR) mode, [HDR Capture] is fixed to [Auto] and the
Auto Align function is enabled.
• If [One Push File Format] is assigned to the V/Y button, pressing the button
temporarily deactivates HDR Capture and saves captured images in RAW+.
HDR Capture
HDR Capture
HDR Capture
HDR Capture
Auto Align
Auto Align
Exposure Bracket Value
Exposure Bracket Value
Cancel
Cancel
MENU
157
OK
OK
OK
5
Advertisement
Table of Contents
