Table of Contents
Advertisement
Using the Built-in Flash
70
Use a flash to take pictures in low light or backlit conditions.
The built-in flash is optimum for a subject at a distance from approx. 0.7 m
to 5 m. Vignetting (darkening of the corners of the image due to a lack of
light) may occur when used at a distance closer than 0.7 m (this distance
varies slightly depending on the lens being used and the sensitivity setting
(p.252)).
3
• When using the built-in flash, remove the lens hood before shooting.
Vignetting may occur depending on the lens being used and the shooting
conditions. Refer to "Lens and Built-in Flash" (p.273) for details.
• The built-in flash always fully discharges when using a lens without an s
(Auto) position.
For details on the built-in flash and instructions on how to take pictures with
an external flash, refer to "Using the Flash" (p.249).
Setting the Flash Mode
Flash Mode
Auto Flash
C
Discharge
Auto Flash+
i
Red-eye Reduction
Flash On
E
Flash On+
F
Red-eye Reduction
Slow-speed Sync
G
Slow-speed
H
Sync+Red-eye
Automatically measures the ambient light and
determines whether to use the flash.
Discharges a pre-flash for red-eye reduction before
the automatic flash.
Discharges the flash for each picture.
Discharges a pre-flash for red-eye reduction before
the main flash.
Sets to a slow shutter speed depending on the
brightness. When using this to shoot a portrait with
the sunset in the background, both the person and
the background are captured beautifully. (p.250)
Discharges a pre-flash for red-eye reduction before
the main flash is discharged with Slow-speed Sync.
Function
Advertisement
Table of Contents
