Table of Contents
Advertisement
TROUBLESHOOTING
What appears troublesome may be easily remedied. Here are some problems that may occur and their remedies.
Symptoms
Causes and Remedies
1.
The shutter cannot be
released.
•
Is the main switch turned off? If so, turn it on. (See page 6.)
•
Are the batteries exhausted or loaded? Replace them or insert
new batteries if they are exhausted. (See page 41.)
•
Is your subject out of the focusing range? Shoot in the range of
0.8 meter to infinity for ordinary photography. (See page 12.)
•
Is (uu©) blinking on the LCD panel? If so, the film has been used
up. Insert a new roll. (See page 19.)
2.
My printed pictures don't
look very clear.
•
Did you position the autofocus frame on your subject? (See page
14.)
•
Did you obstruct the autofocus window with your fingers or hair
when you pressed the shutter release button? (See page 7.)
•
Water drops or dirt on the lens protective glass, autofocus
window and light sensor window will prevent you from taking
good pictures. Clean them before taking pictures. (See page 15.)
3.
Zoom lens retracted
automatically (the power is
turned off automatically).
•
Did you leave the camera unused for over 3 minutes after the
main switch was turned on? The power is automatically switched
off if the camera is left unused for over 3 minutes. (See page 6.)
•
Was the Remote Controller removed from the camera? When the
camera is left unused for more than 10 minutes with the Remote
Controller removed, the camera automatically switches itself off
to save battery power. Push the main switch again to turn it on.
(See page 34.)
Advertisement
Table of Contents
