Connections; Cpf180I Connection Table - Standard Horizon CPF180i Owner's Manual

Smart GPS Cable
Pin Wire Color
1 Red
2 Green
3 Brown
4
5
6 Black/Yellow
2.4

CONNECTIONS

The CPF180i and CPF300i have connectors that allow them to be connected to a power
supply, optional WAAS GPS antenna, NMEA Devices* such as Optional Video Camera
(CPF300i only) VHFs, AIS Receiver, Digital Instruments and autopilots.
The GPS Chart Plotter can send many sentences to external NMEA devices*. The NMEA Output
wires are yellow and white (CPF180i and CPF300i) and white (CPF300i). If you have connected
devices as shown in the following table and need to feed NMEA to other devices (Autopilot,
RADAR...) you can parallel wires from the yellow, brown or white wires to other devices.
RS232 not opto-isolated electrical interface
2.4.0

CPF180i Connection Table

Power Data Cable
Pin Wire Color Description
1 Black Battery Ground
2 Red Battery Positive
3 Green NMEA Common
4 Blue Port1 Input
5 Brown Port1 Output
6 Grey NC
7 White NC
8 Yellow Port 3 Output
CPF180i and CPF300i
Figure 2.3.0a - Installing the External GPS antenna (II)
Description
Battery Positive
Smart GPS NMEA Input
Smart GPS NMEA Output
NC
NC
Battery Ground
NOTE*
Connection Example
Connect to Battery Ground
Connect to Battery Positive
Common (ground) for NMEA devices**
Connect to Output of NMEA devices**
Connect to Input of NMEA devices**
Connect to Input of NMEA devices**
NOTE
Additional Comments
Default is NMEA0183
Default is NMEA0183 with GGA, GLL, RMC,
DBT, DPT, MTW, VHW and XTE sentences
Default is NMEA0183 with APA, APB, BOD,
GGA, GLL, RMC and XTE sentences*
Page 21