Aaeon PCM-4330 Instructions Manual page 32

Select base address for parallel port
Automatic assignment at start-up
Address and interrupt
Not active
Select mode for active parallel port
Bidirectional
EPP
ECP
EPP+ECP
Activate/deactivate primary (on-board) IDE-Controller and IDE-/AT-Bus interface
Automatic detection at start-up
IDE-Controller off
IDE-Controller on
Activate/deactivate on-board Floppy Disk Controller and floppy disk interface
Automatic detection at start-up
FDC-Controller off
FDC-Controller on
Select mode for floppy disk drives
Standard assignment
Swap drive letter assignment
Enable/disable onboard PS/2-mouse port.
Please note: This function is not supported on the PCM-4330 platform.
Auto
3BCh, IRQ7
378h, IRQ7
278h, IRQ5
Disable
Auto
Disable
Enabled
Auto
Disable
Enabled
Normal
Swap A:/B: